4 配置路由

总配置效果图，注意comment的设置，在运行脚本时要用到

可以看到，我在路由表中加入了3条规则，前两条分别对应于在mangle中设置的两个路由标记

另外一条没有路由标记，官方解释说是用于路由被标记之外的ros本身的包，具体什么意思我也没有彻底明白



5 加入防adsl掉线脚本

:local assign-address

:local new-address

:local status

:local x

:set x 2

:for i from=1 to=$x do={

:set status [/interface get [/interface find name=(\"pppoe-out\" . $i)] running]

:if ($status=true) do={

:set new-address [/ip address get [/ip address find dynamic=yes interface=(\"pppoe-out\" . $i)] address]

:set new-address [:pick $new-address 0 ([:len $new-address] -3)]

:set assign-address [/ip address get [/ip address find dynamic=no interface=(\"pppoe-out\" . $i)] address]

:set assign-address [:pick $assign-address 0 ([:len $assign-address] -3)]

:if ($assign-address != $new-address) do={ /ip address set [/ip address find comment=$i] address=$new-address network=$new-address broadcast=$new-address

/ip route set [/ip route find comment=$i] gateway=$new-address

/ip fir nat set [/ip fir nat find comment=$i] to-addresses=$new-address

/ip route set [/ip route find comment=$i] gateway=$new-address

}

}

}

配置截图：



再到system->scheduler中加入一条



至此，双线adsl的配置就大功告成了！

目前我只尝试了2条ad负载均衡，不知道3条，4条是不是可以直接按照2条的思路去扩展，哪位仁兄做出来了希望给点思路，谢谢！

上一页  [1] [2] [3] [4]